Home ->
Resources >
Support >
Talgil Filtron 10 - Electronic DP Sensor Installation Instructions
< Back to Support

Talgil Filtron 10 - Electronic DP Sensor Installation Instructions

Step 1 - Remove the back lid

Step 2) Remove the Top case and unscrew the two screws on the top of the controller

Step 3) Remove the Output card, unscrew the two screws and remove the back lid

Note: To remove the Output card - Pull the card towards you (down) and gently lift the card up (a few mm) - Then pull the card towards you to completely remove it from the socket.

Step 4) Install the DP Sensor and connect the wires to the terminals

Note: Wiring from top:

WHITE

BLACK

GREEN

RED

Step 5) Secure the DP Sensor to the controller's case

Note: Make sure that the RED output is facing OUT

STEP 6) Close the back LID, screw the lid to the controller's case

Note: Make sure to install the Output card back to the socket.

PDF - Download Icon
Installation Instructions
DOWNLOAD

BIC 100 Controller